Select Page

Point Motor & Control Panel Switch Installation – Part 2

Part 2 of 2 – In this 2nd Part Jason from Barnabas show the point motor installation, wiring them up and then connecting to the control panel for operation. This is a very delicate procedure, drilling up through the baseboard and not cause any damage to the already fitted & ballasted point. The point motors being fitted are Gaugemaster PM-2. N.B. This setup is Jason’s method for installing simple to operate insulfrog points. Do you have a better way? Let us know in the comments below.
Print Friendly, PDF & Email

About The Author


Favourite Scale: OO / 1:76 Likes: Making small stuff on the laser cutter Dislikes: Counting rivets Other info: Starting to dabble with the world of 3D printing a bit to enhance the products we create on the laser. Layout: Whitwick Grove

Leave a reply

Become A VIP Today!